TPM solvent for washing prints, 5l canister

On storage. Fast delivery.

79.00


Available delivery methods: Nouto varastosta, Lähettipalvelu, Delivery to workplace (Express-paketti), Postipaketti (pakettiatm/ posti), Kotiinkuljetus (Posti Kotipaketti 21), Delivery to EU countries, Express-parcel inside Finland, Parcel Connect, Trolley shipment, Printer shipment, Delivery for Formlabs Fuse1

Tripropylene glycol monomethyl ether (TPM) is a non-flammable, low odor solvent that can be used to clean and dissolve uncured resin on stereolithography (SLA) 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before needing to be replaced. 

TPM is not currently certified for use with Formlabs biocompatible resins.

Formlabs generally recommends using isopropyl alcohol (IPA) with a concentration of at least 90% to wash parts. If you are unable to use IPA, TPM is a tested alternative.

TPM is compatible with the Formlabs Finish Kit, Form Wash, and Form Cure.

This product is not labeled as dangerous according to Regulation (EC) No. 1272/2008.

Additional product information

Safety Data Sheet Download
KäyttöturvallisuustiedoteSE Download
KäyttöturvallisuustiedoteEng Download

Accessories

Product Note Status Price
Form Cure Form Cure
699.00 €
Form Wash Form Wash
549.00 €
Isopropyl alcohol (IPA), 20l. Isopropyl alcohol (IPA), 20l.
200.00 €
Display accessory details

Browse these categories as well: Supplies, Formlabs, Formlabs supplies