Switch country/language: United Kingdom (English)

TPM solvent for washing prints, 5l canister

Product no.: TPM-5l

The product is currently not available in stock.

99.00 €

Available delivery methods: Pick up from the warehouse, Courier service (ONLY Helsinki capital region), Delivery to workplace (Express-paketti), Postipaketti (pakettiatm/ posti)

Description

Tripropylene glycol monomethyl ether (TPM) is a non-flammable, low odor solvent that can be used to clean and dissolve uncured resin on stereolithography (SLA) 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before needing to be replaced.

TPM is not currently certified for use with Formlabs biocompatible resins.

Formlabs generally recommends using isopropyl alcohol (IPA) with a concentration of at least 90% to wash parts. If you are unable to use IPA, TPM is a tested alternative.

TPM is compatible with the Formlabs Finish Kit, Form Wash, and Form Cure.

This product is not labeled as dangerous according to Regulation (EC) No. 1272/2008.