Everything you need to stick and release polycarbonate filaments reliably

This is MagigooPC, the adhesive specifically designed for 3D printing in polycarbonate plastics. It offers a strong adhesion platform for polycarbonate based filaments. 

Magigoo is an easy to use 3D printing adhesive designed to reduce warping in FDM/FFF 3D printers. Warping, among other factors, is caused by the differential cooling of a print during a 3D printing process. 

For printing repeatability and reliability remember to apply Magigoo PC (orange label) on your print bed before printing in polycarbonate. This will ensure a successful print.

Magigoo adhesion glue made especially for glass fiber polypropylene, like BASF Ultrafuse PPGF30

Polymaker PolySher

http://www.polymaker.com/shop/polysmoothpolysher/

Using an adhesion sheet is one of the most effective methods of ensuring your 3D print adheres to the build plate, producing consistent high-quality results.

Package contains 25 sheets

Instructions

Dimafix Pen (90ml) is a new product based on Dimafix formula. It has long been useful (more than 100 uses). It is water soluble so it is easy to clean. It works on different temperature range than Dimafix gas, so it allows the self detaching effect of the piece sooner. This product does not contain any gas, is enviromentally friendly. Notice also the pleasant aroma during printing with dimafix. Shake well before use. After use, close and hold the bottle upright.

PrintaFix is specially developed for FDM 3D printing to eliminate warping effective. You do not need any other adhesion agent anymore. PrintaFix is simpler to apply and has superior adhesion qualities compared to all other solutions on the market. The spray may be used on unheated and heated pressure beds.

Unique features

• cost-effective application
• quick and simple application: Shake and spray
• environmentally friendly unlike hairspray and other solutions
• removeable with warm water!

Application

1. Remove the printbed from the printer. Shake the PrintaFix bottle well for 5 seconds.
2. Hold the PrintaFix bottle 10cm (4″) away from the printbed. Use enough spray strokes to cover the entire printbed with a thin film of the solution. Overlap spray strokes to prevent uncovered areas that could affect the adhesion. Let it dry for 30 seconds.
3. Start the print process with the recommended settings.

When your print has finished remove it carefully with a spatula. Clean up of PrintaFix can be done with warm water, an alcoholic solution or PrintaClean

PrintaGlue is a universal superglue that has been chosen to work with a wide variety of 3D printing materials. It combines strength, quality, and durability for perfect results. It is always good to have Superglue in next to your 3D printer, as you never know when you will need a quick repair. PrintaGlue comes in easily portable 10g bottles, which last for many secure connections.

Instructions

1. The contact surfaces should be dry and free of contamination like oil or grease. Apply the adhesive sparingly to one surface.
2. Press together immediately. Hold in place for 15 to 30seconds until bond sets.
3. Let product rest for a while to give the glue time to fully harden. After 24h the bond has been fully set.

Basic build plate adhesion glue for PLA, PETG, Flexible and other materials, which do not require strong adhesion.

Using the Ultimaker cleaning filament is the most effective way to unclog and keep print cores in optimal condition. Filament size 2.85mm

Instructions

SuperSlip oil for FDM/FFF 3d-printer rods.

Now and then apply to rods and gliding profiles only.
Rotate end of stick a few times. Later 1 click now and then.

• High tech lubricant which will never dry out, ever!
• Never turns into grease or wax.
• Will not corrode your parts.
• Not poisonous!

Use sparingly, creates a film layer of gliding surface!
5ml.